XF Forum banner

Is the technology that the Ingenium engine needed.

969 views 5 replies 4 participants last post by  BMVIrep  
#1 ·
Will this technology render Jaguar’s new Ingenium Petrol engine outdated ?


Renault launches new generation gasoline engine, co-developed by Alliance and Daimler


7 December 2017

Renault has introduced a new direct injection turbocharged 1.3 gasoline engine co-developed by the Alliance and Daimler. Inaugurated on the Scénic and Grand Scénic, it will be progressively offered in the Renault range beginning in 2018.

This new engine offers significant improvement in driving performance, with better torque at low rpm and greater and constant availability at high rpm, while reducing fuel consumption and CO[SUB]2[/SUB]emissions.

Compared with the Energy TCe 130, the new Energy TCe 140 delivers 35 N·m additional peak torque which is available across a broader rev band, from 1,500 rpm to 3,500 rpm, said Philippe Brunet, Alliance Global VP – Powertrain & Electric Vehicles.




The new engine is available in a variety of power ratings from 115 hp to 160 hp. The Energy TCe 160 engine offers a maximum torque of 260 N·m with manual gearbox and 270 N·m with EDC gearbox when reaching maximum power.

This maximum torque is reached from 1750 rpm and up to 3700 rpm. Orders in France and Europe are now open and deliveries to customers are scheduled for mid-January 2018.

It incorporates several recent Alliance-developed innovations, including Bore Spray Coating, a cylinder coating technology from the Nissan GT-R engine, which improves efficiency, by reducing friction and optimizing heat transfer.

Other technologies enhance driving enjoyment and reduce fuel consumption and CO[SUB]2[/SUB] emissions: the pressure of the direct fuel injection has been raised by 250 bar and a specific combustion chamber design optimises the fuel/air mix.

In addition, Dual Variable Timing Camshaft technology controls the intake and exhaust valves according to engine loads.

The result is more torque at low revs and more linear torque available linearly at high revs, for significant benefit in terms of driving comfort with better mid-range response
 
#2 ·
#3 ·
Don't forced induction engines normally have a fairly constant torque output through a good proportion of the rev range? Is 1,500 - 3,500 revs really a "broader rev band" for a petrol engine? Is 3,500 revs really "constant availability at high rpm"? I suppose a dyno would tell a better story.
 
#4 ·
Will this technology render Jaguar’s new Ingenium Petrol engine outdated ?
No. The engine is mainly for cheaper C-segment cars. Mercedes' version, 'M282', will go into the new A-Class in March next year:

https://www.autocar.co.uk/car-news/industry/new-entry-level-mercedes-benz-petrol-engines-way

The torque is impressive though - higher per litre than the top-level Ingenium petrol.

If it is made in Nissan-Daimler's 'COMPAS' plant in Mexico, it will be a lot cheaper than Wolverhampton.
The technology, not the engine.
I understood that Mercedes were going to use the same technology in a 2 litre AMG ?
 
#5 ·
This is a very poorly written article - it almost reads like a poor google translation.

There is no "new tech" in this engine. Run-of-the-mill small, cheap engine.