XF Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
ok im new to thus forum as i cant find answers , ok so rear camber on my xf is out my tyre is shredded on the inside so camber is tilted inwardsat the top , us there any way at all to correct this, as no adjustment ,i have replaced the upper arm but still the same


Thanks
50072
 

·
Registered
Joined
·
2 Posts
Well, if I had to guess I'd say your end links were bad and it's thrown your rear alignment out of spec. The bushings & ball joints are legendary for their short life span on all DEW98-based Jaguars, so it would probably be a good idea to check them all while you're down there
 

·
Registered
Joined
·
61 Posts
I find I get same type of wear - inside edges on the rears and also outside edges on the fronts.
Camber and alignment checked a few times and it's always been pretty much bang on (4-wheel alignment check).
Car is a Sportbrake running on (factory optional) 20" rims with 255/35 tyres.
I've upped pressures by 3psi above book which seems to help, but ultimately uneven wear seems to be a trait.
Best solution I have found is to swap fronts and rears periodically to even out wear on inside and outside edges!
 
1 - 5 of 5 Posts
Top